VO-BB - 19 YEARS OLD! Forum Index VO-BB - 19 YEARS OLD!
Where A.I. is a four-letter word.
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Pro Tools and snap-to zero crossings

 
Post new topic   Reply to topic    VO-BB - 19 YEARS OLD! Forum Index -> Gear !
View previous topic :: View next topic  
Author Message
Mike Harrison
M&M


Joined: 03 Nov 2007
Posts: 2029
Location: Equidistant from New York City and Philadelphia, along the NJ Shore

PostPosted: Wed May 27, 2020 7:07 pm    Post subject: Pro Tools and snap-to zero crossings Reply with quote

Can any Pro Tools users (especially users of recent versions) tell me if there is an option to ensure the start- and end-points of selections will automatically snap to the point where the waveform crosses the zero line?

If an edit is made at any point in the waveform other than the zero crossing, a pop will be heard.

Thanks!
_________________
Mike
Male Voice Over Talent
I have taken leave of my sensors.

Back to top
View user's profile Send private message Send e-mail Visit poster's website
Matto
Club 300


Joined: 27 Nov 2007
Posts: 386
Location: Vancouver Island, British Columbia

PostPosted: Thu May 28, 2020 12:37 pm    Post subject: Reply with quote

Following with interest, as an enthusiastic Pro Tools amateur...
_________________
www.mattcowlrick.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    VO-BB - 19 YEARS OLD! Forum Index -> Gear ! All times are GMT - 7 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group